Wenn nach einem Stromausfall das Betriebssystem der Stora MS2110 nicht mehr reagiert, kann folgende Prozedur helfen. Sie beschreibt die komplette Neuinstallation des Systems ohne die Datenpartition zu verändern.
• To put the device into recovery mode, power on the device, wait 15 seconds, then hold the reset button while bootup continues.
• The bootup process will take approximately 30 seconds and the blue LED will be blinking during that period.
• As soon as the recovery mechanism kicks in, the blue light turns off and HDDLED1 will turn orange. The reset button can be released at this point.
• Then the device will request a DHCP lease and try to get an IP
• If an IP is obtained, HDDLED2 will also turn orange for 1 second.
• If no IP is assigned the following pattern will be shown on the leds and the recovery mechanism will stop (Power LED Off → HDDLED1 and HDDLED2 will blink 3 times together → All LEDs off).
• Once network is up, the download and burn process will begin. During the download procedure the LED behaviour is: Power LED Off → HDDLED1 and HDDLED2 will turn on and off in turns
• The download and burn will take around 4-5 mins with a fast connection speed.
• Once the download and burn is done:
• If the burn is successful, all LEDs will turn on for 5 seconds and then the device will reboot normally
• If the burn fails the LED behaviour will stay as follows and the recovery mechanism will stop (Power LED On → HDDLED1 and HDDLED2 will blink together).
Then you can re-configure your device using the Setup CD, use the same product key, Stora name and create the same Stora accounts to recover your data.